ADO A16 A26 A20 A20F 350W/500W Ebike DC Motor Controller Rear light Reflector Electric Bicycle Replacement Parts

Specification Rated voltage36VLimit current15A±1AOvervoltage protection64VMatching motor350W A16 A20500W A20F A26Overcurrent protection time2 5mSAverage driving current7A±1AThrottle voltage0 8 3 7VUndervoltage protection30VMatching models 1 A16 2 A20 3 A20F 4 A26Size93x55x30mmTaillight installation Guide 1 Clip the new taillight bracket to the seat tube And tighten the screws 2 Align the tail light with the bracket and snap it into the clip 3 Unplug the isolation tape Use the light through the switch button at the bottom of the light 4 The front and rear shells of the lamp can be opened through the separation film position and the AAA battery of the lamp can be replaced Steps to Replace the Controller 1 First arrange the cable of the new controller in order 2 Open the control box of the bicycle take out the old controller and some wires 3 Organize the order of the old controllers and cables 4 In the order of the above chart Disconnect the No I cable motor power cable of the old controller Connect the No I cable motor power cable to the new controller according to the color 5 In the order of the above chart Disconnect the No 2 cable motor hall cable of the old controller Connect the No 2 cable motor hall cable to the new controller 6 Follow the above method Transfer 1 cable from the old controller to the new controller every time 7 After completing the transfer of these 11 cables Put the new controller into the control box first Put